How to use a hanger?
It’s a pipe, 1 3/8 inches, cold roll rod that’s bent. We use these temporary hangers when we are running out the chain link fence, whether rolling it out on the ground or coming out of our Installink machine, we are going to use this to hang the fence with it.
How I use it, I just pass it through the chain link mesh, and I hang it on top of the top rail. I just pop it through the top of the fabric and hang it over the top rail. This will hold it to about the right height that I want for when it comes time to tying. I will leave those hangers there until I actually tie.
When it comes time to tie,
A lot of times it will want to fall a little bit too low here. What most of my customers and I will do is to turn them up so it’s nice and straight like this. It raises it a half inch further which allows a little of the diamond to come up here to make it look a little bit better for the chain link fence. That’s usually how I dress my fences. I turn up the hangers before I tie them.
The hangers are then taken off after it is tied and then reused so you don’t have to waste them. I’ll put one of these hangers typically after every line post. As it’s coming out of the Installink machine, the Installink does pull it pretty tight so it dresses it somewhat – takes out those sways because of the tension behind it – and if I put this behind it will actually hold that dressing from swooping down every ten feet. But if I’m doing it by hand, sometimes I’m going to put them on every five feet just to keep it dressed a little better before I stretch it.
That’s also why I like to use aluminum fabric rather than galvanized fabric.
It will typically dress better unless it’s pre-galvanized which will dress itself very nice like aluminum would but if it’s galvanized after weave sometimes the icicles will hold the fence from dressing out properly – easily. It’s just a little bit easier if it’s aluminized or pre-galv. The 1.2 ounce is typical. Your 2-ounce galvanized, if it’s after weave, it’s definitely harder to do because of the extra galvanizing on it. It just wants to hold it up.
That’s our typical hanger. We use them on almost every job. We even use them on residential jobs.
As leaders in the Michigan,
HomeL&C Enterprise-USA believes placing emphasis on working with people. We are dedicated to Homeproviding fencing solutions that keep you safe, secure and look elegant. We believe that the products L&C Enterprise-USA offers, helps take the strain off of your fence crews and satisfy your customers. Leadership is by example.
If you live, work or play in Upper Michigan and are looking to learn more about residential fencing. Delta Fence & Construction can help! Call us at (906) 786-1076 or visit www.deltafenceman.com to schedule an appointment today.
Where can I buy the fence hangers shown in your blog and video?
Thanks!